Service Repair Manual

SERVICE ADJUSTMENT PROCEDURES (FBC)

INSPECTION AND ADJUSTMENT OF

ACCELERATOR CABLE FREE PLAY

1. Run the engine until it reaches the specified idle speed.

2. Confirm that the accelerator inner cable has no slack.

3. If it shows slack, adjust it as follows:

Loosen the adjusting nut so that the throttle lever is free.

Turn the accelerator adjusting nut to the point where the

throttle lever just starts moving, then back off one turn

and secure the lock nut.

FUEL GAUGE UNIT REPLACEMENT

1. Remove the plug located on the trunk floor.

2. Disconnect the fuel gauge unit connectors.

3. Remove the fuel gauge unit.

After installing the fuel gauge unit, confirm that the unit is

grounded.

5. When installing the plug on trunk floor, apply a specified

sealant around the plug mounting surface.

31-105