Service Repair Manual

CARBURETOR
25. Remove the pilot jets and main air jet.
NOTE
When removing the jets, use a screwdriver that is an exact
fit for their slot and work carefully to prevent damage.
26. Carefully lift and swing up the roll-over device weight from
the bottom of the float chamber, then use a magnet to
remove the roll-over steel ball.
NOTE
Remove the float chamber gasket and pour the remaining
fuel contained in the float chamber into a container.
27. Remove the accelerator pump outlet check ball and weight.
NOTE
Invert the chamber to remove the accelerator pump outlet
check ball and weight located at the gasket surface.
28. Separate the float chamber from the throttle body.
31-122