Service Repair Manual

CARBURETOR
NOTE
When reinstalling, apply thread sealant to the screws and
be sure the pump body, gasket and cover are properly
positioned.
36. Remove the E-clip and outside washer on the secondary
throttle shaft and slide the diaphragm spring link off the
throttle shaft.
37. Remove the two screws attaching the diaphragm bracket to
throttle body and remove the secondary throttle diaphragm.
38.
39.
40.
41.
Using a 10 mm wrench, remove the nut attaching the
accelerator pump lever to the throttle shaft.
With the impact driver, remove two screws attaching the
throttle position sensor to the throttle body.
Remove the E-clip holding the throttle position sensor onto
the throttle shaft.
For removal of plug, clamp carburetor in a vice and drill a
2mm (5/64 in.) pilot hole in the casting surrounding the idle
mixture adjusting screw (MAS) then redrill the hole to 3mm
(1/8 in.)
Insert a blunt punch into the hole and drive out plug.
31-124