Service Repair Manual

CARBURETOR

Unloader Opening

Lightly press the choke valve with a finger to fully close it.

In this state, fully open the throttle valve and measure the

choke valve to choke bore clearance.

Standard value

. . . . . . . . .

1.9-2.1 mm (0.075-0.083 in.)

If the clearance is out of specification, bend the throttle lever

at illustrated portion to adjust the clearance to the standard

value.

Choke Breaker

CAUTION

Check and adjust with the bimetal assembly removed.

Lightly press the choke valve with a finger to fully close it.

2. Push the choke breaker rod toward the diaphragm and

measure the choke valve to choke bore clearance.

Standard value

1st stage

. . . . . . 1.4-1.6 mm (0.055-0.063 in.)

2nd stage

. . . . . . . 2.9-3.1

mm (0.114-0.122 in.)

If the clearance is out of specification, adjust by bending the

throttle lever at illustrated portion.

31-131