Service Repair Manual

ENGINE CONTROL (FBC)
4. Disconnect the accelerator cable guide from the fire wall,
and then remove the accelerator cable.
Accelerator Pedal
1. Loosen the accelerator cable adjusting nut, and disconnect
the accelerator cable from the accelerator arm and remove
the accelerator pedal.
2. Remove the return spring from the accelerator arm.
3. Remove the cotter pin from the accelerator arm shaft, and
then remove the accelerator arm from the accelerator arm
bracket.
INSPECTION
1. Check the inner and outer cables for damage.
2. Check the cable for smooth movement.
3. Check the accelerator arm for bending.
4. Check the return spring for deterioration.
5. Check for connection of accelerator cable to end fitting.
INSTALLATION
1. Apply the specified multipurpose grease around the each
moving point of the pedal.
Recommended multipurpose grease . . . . . . . . . . . . . . . . . . . . .
Multipurpose grease SAE J310a, NLGI
grade #2 or equivalent
31-134