Service Repair Manual

MPI SYSTEM
Overfill Limiter (Two-way Valve) Replacement
1. Disconnect the vapor hoses and the overfill limiter.
Fuel Sender Replacement
1. Remove the fuel filler cap to lower the fuel tank’s internal
pressure.
2. Disconnect the harness connector from the fuel sender.
3. Remove the fuel sender unit installation screws, then
remove the fuel sender assembly from the fuel tank.
Fuel Pump Operation Check
1. Turn the ignition switch to OFF.
2. Apply battery voltage to the fuel pump drive connector to
check that the pump operates.
NOTE
The fuel pump is in-tank type and its operating sound is
hard to hear without removing the fuel filler cap.
3. Pinch the fuel hose to check that fuel pressure is felt.
31-24