Service Repair Manual

INJECTOR AND THROTTLE BODY (MPI)

Remove the delivery pipe with the fuel injector and pressure

regulator.

CAUTION

Be careful not to drop any injectors when removing the

delivery pipe.

2. Be aware that fuel may flow out when removing the

injector.

INSPECTION

1. Measure the resistance of the injectors between the

terminals using an ohmmeter.

Resistance . . . . . . . . . . . . . . . . . . . .

.13-16n

[at 20°C (68ºF)]

2. If the resistance is not within specifications, replace the

injector.

INSTALLATION

1. Install a new grommet and O-ring to the injector.

2. Apply a coating of solvent, spindle oil or gasoline to the

O-ring of the injector.

While turning the injector to the left and right, install it on

to the delivery pipe.

4. Be sure the injector turns smoothly.

NOTE

If it does not turn smoothly, the O-ring may be jammed;

remove the injector and re-insert it into the delivery pipe

and re-check.

31-55