Service Repair Manual

FUEL TANK (MPI)

6. Test the two-way valve for proper operation.

To check the two-way valve, lightly breathe into the inlet and

outlet. If air passes through after slight resistance, then the

valve is good.

INSTALLATION

1. Confirm that the pad is fully bonded to the fuel tank, and

install the fuel tank by tightening the self-locking nuts to the

tank bands until the rear end of the tank band contacts the

body.

Connect the leveling hose to the tank and approximately 40

mm (1.6 in.) at the filler neck.

3. When connecting the filler hose, the end with the shorter

straight pipe should be connected to the tank side.

4. Connect the vapor hose and return hose.

When attaching the fuel hose to the line, be sure that the

hose is attached as shown in the illustration.

31-62