Operation Manual

HYUNDAI
12
Connecting to power supply
This product is designed with a cord retainer (8)
that prevents the extension cord from being pulled
loose while using.
Always use cord retainer to properly
attach extension cord to the machine.
Failure to use cord retainer may result
in damage to the machine and/or
extension cord.
• Form a loop with the end of the extension cord.
• Insert loop portion of extension cord through
opening and place over cord retainer.
• Slowly pull loop against cord retainer until the
slack is removed.
• Plug product into extension cord.
Failure to remove all excess cord slack
from extension cord retainer could
result in plug loosening from
receptacle.
DESCRIPTION (fig. A)
This device can be used as a weed killer, paint
remover and lighter for barbecue and fireplace.
Use this appliance for the intended purposes only!
Other forms of use can lead to injuries or
accidents!
1. On/off switch
2. Hot air nozzle
3. Stand
4. Ventilation openings
5. Extension handle connection
6. Extension handle
7. Handle
8. Cord retainer
Nozzles (fig. B)
9. Nozzle for weed control
10. Nozzles for paint removel
11. Nozzle for barbecue/fireplace lighter
Packaging contents
The packaging contains the following
components:
• Weed burner
• Nozzle for weed control
• 2 nozzles for paint remover
• Nozzle for barbecue/fireplace lighter
• Extension bar
• Handle
OPERATION
Always use with caution! Do not cover
the ventilation openings during use as
it causes a risk of burns! Do not touch
the hot nozzle!
Temperature settings
With the temperature switch (6) you can select
from two temperature settings.
Setting I 50 °C (venting/ cooling)
Setting II 600 °C
The volume of air in each setting 500 l /min.
To turn on the power
• Push the switch (1) in position I or position II.
To turn off the appliance
• Push the switch on position 0.
To install the nozzle
The nozzles can easily be pushed over the hot air
nozzle. Never touch the nozzles during or
immediately after use of the device. The nozzles
are very hot.
INSTRUCTIONS FOR USE
Weed burner
Assemble the extension handle:
The extension handle consists of two parts.
Connect both parts and attach the extension
handle to the device. To attach the extension
handle, place the extension bar in the machine
and turn the extension handle a quarter turn to the
right. Make sure that the extension handle firmly
clicks into position.
If using the device as a weed killer you
must use the extension handle. Hold
the weed killer firmly by holding the
end of the extension handle.
Ensure the extension handle is firmly fixed onto
the device and that the device is turned off.
• Install the nozzle (9) to destroy weeds.
• Insert the plug into the socket.
• Check to ensure the nozzle is not blocked
before turning the device on.
• Set the temperature to setting II.