Parts and Accessories List

energy emitted by radio and telecommunications equipment. These

standards prevent the sale of mobile devices that exceed a maximum

exposure level (known as the Specific Absorption Rate, or SAR) of

1.6W/kg. SAR information on this and other model devices can be

accessed online on the FCC’s website through

transition.fcc.gov/oet/rfsafety/sar.html.

In normal use, the actual SAR is likely to be much lower, as the

device has been designed to emit only the RF energy necessary to

transmit a signal to the nearest base station. By automatically emitting

lower levels when possible, your device reduces your overall exposure

to RF energy.

The FCC has granted an Equipment Authorization for this model

device based on the compliance of all reported SAR levels with the

FCC RF exposure guidelines. This device has a FCC ID number :

2AZP5-E485TA [Model Number : E485 and the specific SAR levels

for this device can be found at the following FCC we6bsite :

www.fcc.gov/oet/ea/.

FCC Warning

15.19 Labeling requirements.

This device complies with part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

15.21 Information to user.

Any Changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate

the equipment.

15.105 Information to the user.

Note: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and,

if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio