Owner's Manual

953
Maintenance
Front fog light
1. Turn off the engine.
2
. Remove the wheel housing by
removing the screws.
3. Reach your hand into the back of the
front bumper.
4. Disconnect the power connector from
the socket.
5. Remove the bulb-socket from the
housing by turning the socket counter
clockwise until the tabs on the socket
align with the slots on the housing.
6. Install a new bulb-socket into the
housing by aligning the tabs on the
socket with the slots in the housing.
Push the socket into the housing and
turn the socket clockwise.
7. Connect the power connector to the
socket.
Side repeater light bulb
replacement (if equipped)
1. Remove the light assembly from the
body of the vehicle by prying the lens
and pulling the assembly out.
2. Disconnect the bulb electrical
connector.
3. Separate the socket and the lens part
by turning the socket
counterclockwise until the tabs on the
socket align with the slots on the lens
part.
4. Remove the bulb by pulling it straight
out.
5. Insert a new bulb in the socket.
6. Reassemble the socket and the lens
part.
7. Connect the bulb electrical connector.
8. Reinstall the light assembly to the
body of the vehicle.
Rear combination light bulb
replacement
(1) Tail light
(2) Rear turn signal light
(3) Back-up light
(4) Stop light
OHA071029 OHA071030OHA071028