Workshop Manual

WS-12
TROUBLESHOOTING INSTRUCTION
Jumper Wire With Fuse
Use a jumper wire with fuse to by pass an open circuit.
A jumper wire is made up of an in-line fuse holder connected to a
set of test leads. This tool is available with small clamp connectors
providing adaption to most connectors without damage.
CAUTION:
Do not use a fuse with a higher rating then the specified fuse that
protests the circuit being tested. Do not use this tool in any situation
to substitute for input or output at the solid-state control module,
such as ECU, TCU, etc.
Short Finder
Short finder is available to locate short to ground. The short finder
creates a pulsing magnetic field in the shorted circuit and shows
you the location of the short through body trim or sheet metal.