Workshop Manual

SYMBOLS
WIRES
A wavy line means the
wire is broken but
is to be continued.
0.5YEL/RED
Wire insulation is yellow
with a red strip
Current path is continued another
page. The arrow shows the direc-
tion of current flow. You should
look for the ”P” in the Power Dis-
tribution schematic to follow the
white wire in left example.
A wire connects to another
circuit. The wire is shown
again on that circuit which
the arrow is pointing.
A broken line means only someA broken line means only some
of the circuit is shown; refer toof the circuit is shown; refer to
the circuit listed for the com-the circuit listed for the com-
plete schematic.plete schematic.
This dashed line means the
RED and YEL/BLU wires
are both in connector M35.
Where seperate wires join, only
the splice is shown: for details
on the additional wiring, refer
to the circuit listed.
SPLICES
Splices are numbered and shown
as a dot with circle. The exact
location and connection of these
splices may vary among vehicles.
GROUND - “G”
This symbol means the end of
the wire is attached to a metal
part of the vehicle.
Each wire ground (G) is num-
bered for reference in the
component location index.
This ground symbol (dot and 3
lines overlapping the compo-
nent) means the housing of the
component is attached to a
metal part of the vehicle.
SHIELD WIRE
This represents RFI (Radio Fre-
quency Interference) Shielding
around a wire. the shielding is
always connected to ground.