Operation Manual

2-24
Safety system of your vehicle
Seat belt warning light
Seat belt warning light
(for driver’s seat)
■ Type A
As a reminder to the driver, the seat
belt warning light on the instrument
cluster will blink for approximately 6
seconds each time you place the
ignition switch in the ON position
regardless of belt fastening.
If the driver’s seat belt is unfastened
after the ignition switch is in the ON
position, the seat belt warning light
will blink again for approximately 6
seconds.
If the driver's seat belt is unfastened
when the ignition switch is in the ON
position or if it is unfastened after the
ignition switch is in the ON position,
the seat belt warning chime will
sound for approximately 6 seconds.
At this time, if the seat belt is fas-
tened, the chime will stop at once. (if
equipped)
■ Type B
As a reminder to the driver, the dri-
ver’s seat belt warning lights will illu-
minate for approximately 6 seconds
each time you place the ignition
switch in the ON position regardless
of belt fastening.
If the driver’s seat belt is unfastened
when the ignition switch is in the ON
position or if it is disconnected after
the ignition switch is in the ON posi-
tion, the seat belt warning light will
illuminate until the belt is fastened.
Damaged seat belts and seat
belt assemblies will not operate
properly. Always replace:
• Frayed, contaminated, or dam-
aged webbing.
• Damaged hardware.
• The entire seat belt assembly
after it has been worn in an
accident, even if damage to
webbing or assembly is not
apparent.
WARNING
OLMB033022
(Continued)
• No modifications or additions
should be made by the user
which will either prevent the
seat belt adjusting devices
from operating to remove
slack, or prevent the seat belt
assembly from being adjusted
to remove slack.