User's Manual

ER-600 User Manual
46
If add device fails, please first make sure if the SVR2 led light is on, that
means ER-600 has connected to eYun platform. If ER-600 does not
connect to eYun platform, add device will fail.
3) Then Virhub configuration is complete, check if the communication
between host pc and PLC is OK. Open a cmd window, input command:
ping 192.168.3.* (device’s IP address), If there are responses, that
means the communication is OK, and if there is no response for a long
time, please contact eTung technical support.
4) Detect IP address of devices via Virhub
In order that PC running Virhub can communicate with devices at the
far end that connect to ER-600, the devices’ IP must be known
beforehand. Virhub’s “Detect IP” functionality can automatically detect
the devices’ IP .
In Virhub’s interface, right-click the terminal and choose “Detect IP”,
offer the device IP’s subnet area, and then click “Detect IP”; and after a
while, the IPs detected will be shown in the list, as shown in the figure
below:
Figure Appendix 3-7: Detect device’s IP address
Attention:
1) The terminal must be online to use this functinality;
2) Virhub version must be V5.9 or higher.