User's Manual

Receiver Front

1. Power/Link Indicator Light

• Blinking indicator light - Establishing link between the

Transmitter and the Receiver.

• Solid indicator light - Link between the Transmitter

and Receiver has been established and is ready for

signal transmission.

2. HDMI

• The HDMI indicator light will be illuminated when the

HDMI port is selected for video output.

• If there is no signal, and/or the cable is not

connected, the indicator light will blink.

3. COMPO

• The COMPO (component) indicator light will be

illuminated when component output is selected for

video output.

• If there is no signal, and/or the cable is not

connected, the indicator light will blink.

4. AV

• The AV indicator light will be illuminated when the AV

port (composite) is selected for the video output.

• If there is no signal, and/or the cable is not

connected, the indicator light will blink.

5. IR Window

• IR receiving window enables remote control of the

transmitter and/or source components.

6. Link/Output Selection Button

• When powered on: Press for 1 second to select the

video output source. Each press of the button

will cycle through the available video outputs

"HDMI→ COMPO→ AV →HDMI" in sequence.

• Press and hold for 8 seconds until all indicator lights

blink synchronously, you are now in Scan/Pairing

Mode.