Use and Care Manual

GB
10
11
GB
damages. Never open the charger up yourself, have
it repaired by a qualified specialist only and with
original replacement parts. A damaged charger, cable
or plug will increase the risk of an electrical shock.
• Never operate the charger on a surface that will
burn easily (for example, paper, textiles etc) or in
a flammable environment. There is a risk of fire
occurring as a result of the heat generated during the
charging process.
• For best results, your battery should be charged in
a location where the temperature is more that 32 °F
(0°C) but less than that 104°F (40°C). Do not store
outside or in vehicles.
• Fluid can escape from the battery when used
incorrectly. Avoid all contact with this. In the event
of accidental contact, rinse with water. If liquid should
get into the eyes, get medical assistance. Battery fluid
may result in skin irritations and burns.
• Do not open the battery. There is a risk of short-
circuiting.
• Protect the battery from heat, for example, from
constant sun and fire. There is a risk of explosion.
• Never short circuit the battery. There is a risk of
explosion.
• In the event of damages and incorrect use, vapors
may come out of the battery. Ensure plenty of fresh air
and, if you have any symptoms, consult a doctor. These
vapors may irritate the respiratory system.
CAUTION: When battery is not in tool or charger,
keep them away fro metal objects. For example, to
protect terminals from shorting. DO not place battery in
a tool box or pocket with nails, screws, keys, etc. Fire or
injury may result.
Do not put battery into fire or expose to high heat.
They may explode.
WARNING: Do not attempt to disassemble the battery
or remove any component projecting from the battery
terminals. Fire or injury may result. Prior to disposal,
protect exposed terminals with heavy insulating tape to
prevent shorting.
CAUTION: Batteries must be removed from battery-
powered tools and disposed of separately in
accordance with relevant waste battery regulations.
Batteries must never be disposed of with domestic
waste! For details, please contact your municipal authority
concerned.
Accessories
We recommend that you purchase your accessories from
the same store that sold you the tool. Use good quality
accessories and the brand recommended by the vendor.
Sales staff will assist you and offer advice.
6. Safety instructions relating specifically
to the equipment (all locations)
CAUTION! LED is laser class 1! Do not look directly
into the laser as this may result in damage to the eyes.
• Use the appliance, the charger and the attachments, only
for their intended applications!
• Before laying the tool aside, ensure that all moving parts
have come to a standstill.
• Avoid frequent blocking when drilling, tightening or
loosening screws.
• Connect the charger only to a 100V - 240V power supply
using the provided clip on adaptor pins for the local area.
Do Not modify the pin adaptors or the charger plug pack
in any way.
• Charge the tool battery only with the charger supplied.
• Protect the charger and the tool from contact with
moisture. Never immerse in water!
• Do not use the charger in the open air.
• To avoid damage to the batteries, never expose them to
temperatures of over 50 °C.
CAUTION! Do not short-circuit the contacts of the
battery or charger.
• When charging, ensure that the device is correctly
connected („+/–“).
• Do not attempt to burn the battery.
• The connection cord cannot be replaced. In case of
damage, dispose of the device in the correct manner.
In case of damage, dispose of the device in the correct
manner.
Safety notes for battery/charger
• Keep the charger away from rain or damp. Water
entering into the charger will increase the risk of an
electrical shock.
• Keep the charger clean. Contamination will increase
the risk of an electrical shock.
• Check the charger, cable and plug each time you
use the unit. Do not use the charger if you find any
damages. Never open the charger up yourself, have
it repaired by a qualified specialist only and with
original replacement parts. A damaged charger, cable
or plug will increase the risk of an electrical shock.
• Never operate the charger on a surface that will
burn easily (for example, paper, textiles etc) or in a
flammable environment. There is a risk of fire occurring
as a result of the heat generated during the charging
process.
• Do not open the battery. There is a risk of short-
circuiting.
• In the event of damages and incorrect use, vapours
may come out of the battery. Ensure plenty of fresh air
and, if you have any symptoms, consult a doctor. These
vapours may irritate the respiratory system.
Functional description and specifications
WARNING: Disconnect battery pack from tool before
making any assembly, adjustments or changing
accessories. Such preventive safety measures reduce the
risk of starting the tool accidentally.