Operation Manual

EN-17
Specications
General
Power Requirements
..........AC 230V ~ 50Hz
Power Consumption .............................6.5W
Output Power ...................... 7.5W x 2 + 15W
Total Harmonic Distortion .............................
.................................................. 1%(1kHz, 1W)
Audio Input Sensitivity/Impedance LINE: ..
500mV/47kΩ
Frequency Response ....................................
..................................... 40Hz - 20kHz(+0/3dB)
Unit Dimensions (W x H x D) ..........................
...........................................584 x 50 x 218mm
Speaker
Front
Impedance
.............................................. 3Ω
Rate Power .............................................10W
Woofer
Impedance
.............................................. 6Ω
Rate Power .............................................30W
Remote
Distance
....................................................6m
Angle ........................................................ 30
O
Troubleshooting
To keep the warranty valid, never try to
repair the system yourself. If you encounter
problems when using this unit, check the
following points before requesting service.
No power
- Ensure that the AC cord of the
apparatus is connected properly.
- Ensure that there is power at the
AC outlet.
- Press standby button to turn the
unit on.
Remote control does not work
- Before you press any function
 button,rstselectthecorrect 
source.
- Reduce the distance between the
remote control and the unit.
- Insert the battery with its polarities
(+/-) aligned as indicated.
- Replace the battery.
- Aim the remote control directly at
the ensor on the front of the unit.
No Response From the Unit
- Disconnect and reconnect the AC
power plug, then turn on the unit again.