Instruction Manual

Step 10. Click “Sound File setup” button to choose an alarm siren or to record your own

voice message.

Step 11. Click “Save” button to save your pending entry. This entry will be listed at the

bottom section of this window.

Step 12. Repeat step 2 through 4 to add other phone call notification entries.

1. If the user would like to record his own voice message, the “.WAV” file format must

be 8000Hz, 16-bit and Mono for phone call notify.

2. If the user would like to setup the phone notification wave file from the system file, the

warn.wav file should support 8000Hz, 16-bit and Mono format.

3. Each phone call notification entry can have its own unique audio stream, and each

phone call automatically disconnects after one-minute duration even if your voice

message is longer than one minute.

4. You must use an approved Voice Capable Dial-Up Modem.

5. If the user’s telephone system requires an extension number to be inputted, please use

one or several commas (,) to separate the phone number and the extension number.

The number of commas requirement depends on the system, so test it beforehand.

Notify by SMS message. Upon motion

detection, the NVR system will

automatically send the SMS message to

the registered mobile phone. Please

follow the steps below to set up SMS

message notification entries. Before

setting up for SMS message notification,

please refer to “System configuration”

for 3G modem setup first.

Step 1. Click “SMS message” tab.

Step 2. Enter the mobile phone number.