Owner's manual

address, enable/disable DHCP and DNS IP address. The settings must be properly

configured before you operate the IP camera over network. IPv4 and IPv6 are both

supported. Configure the NIC settings, including the IPv4 (IPv6) Address, IPv4(IPv6)

Subnet Mask and IPv4(IPv6) Default Gateway. Click Save to change the setting.

1. If the DHCP server is available, you can check to automatically obtain an IP address and

other network settings from that server.

2. The valid value range of Maximum Transmission Unit (MTU) is 500 ~ 9676.

3. The Multicast sends a stream to the multicast group address and allows multiple clients

to acquire the stream at the same time by requesting a copy from the multicast group

address.

4. Before utilizing this function, you have to enable the Multicast function of your router

and configure the gateway of the network speed dome.

5. If the DNS server settings are required for some applications (e.g., sending email), you

should properly configure the Preferred DNS Server and Alternate DNS server.

6. The router must support the route advertisement function if you select Route

Advertisement as the IPv6 mode.

 PPPoE: If you have no router but only a modem, you can use Point-to-Point Protocol over

Ethernet (PPPoE) function Click this button to enable the PPPoE function, Enter User Name,

Password, and IP address for PPPoE access, then Save to change the setting

and exit the

interface.