Owner's manual

18
Chapter 3: Operation
3-1-2. OSD Display when power on
When power on, the protocol and address will be displayed on
the screen. After the dome accepts the correct commands, the
information will disappear. E.g. ： The screen displays as
following information. The information is as the protocol,
Firmware version, ID Address and Baud rate which have been
setup. Please refer to the right side window screen.
3-2. Menu System
3-2-1. Menu Operation
User can call out OSD menu by entering “ 95+[CALL]” on
keyboard or Press [MENU] button of the controller to enter
the Main Menu.
1.) The item with “→“ are the highlight menu.
2.) Move the joystick right/left/up/down direction to change selection. Press [OPEN] button
to change the parameters.
3.) In the item submenu, lean to right direction of joystick or press [OPEN] button to confirm
the changing. After confirmation, the parameters of current item will be changed.
4.) <BACK> is available in all menu pages. To go back to previous page, move icon “→” to
<BACK> and lean right to confirm. Or press [CLOSE] button on keyboard to go back.
5.) Select <EXIT>, and then press [OPEN] button (lean to right direction of joystick), the menu
will be closed, and the dome exits the OSD programming menu.
SYSTEM INFO
FASTCAM III
VERSION：3.30
BAUD RATE：9600 BPS
PROTOCOL：PELCO-D/P
CAMERA BRAND：Auto
DIP ADDRESS: 001
S/W ADDRESS: 000
Test Ending