Manual

3. Installation and Noise Elimination

Fan

50 mm or more

Airflow

95 mm

or more

[2] DC solenoid valves, magnet switches and relays

Measure: Mount diodes in parallel with the coil or use types with built-in diodes.

In a DC circuit, connecting a diode in reverse polarity will damage

the diode, internal parts of the controller and/or DC power supply,

so exercise due caution.

3.4 Heat Radiation and Installation

Design the control panel size, controller layout and cooling method in such a way that the temperature

around the controller will not exceed 40qC.

Install the controller vertically on a wall, as shown below. Since cooling is provided by way of natural

convection, always observe this installation direction and provide a minimum clearance of 50 mm above

and below the controller to ensure sufficient natural airflows.

When installing multiple controllers side by side, providing a ventilation fan or fans above the controllers

will help maintain a uniform temperature around the controllers.

Keep the front panel of the controller away from the wall (enclosure) by at least 95 mm.

Regardless of whether your system consists of a single controller or multiple controllers, provide sufficient

clearances around each controller so that it can be installed/removed easily.