Owner manual
Table Of Contents
- Software License Agreement
- A Word of Caution
- Table of Contents
- 1 Before You Begin
- 2 Menu Window
- 3 Parameter Window
- 4 Program Run Window
- 5 Program Edit Window
- 6 Program Selection Window
- 7 Point Edit Window
- 8 Axis Status · Move Window
- 9 Input/Output Port · Flag Window
- 10 Global Variable Window
- 11 Clear Memory Window
- Supplement
- Change History
Page 17
5 Program Edit Window
5.3 Program Save and Edit Completion
File → Save
Save the program to a file.
Note: If no name is assigned to the file, the operation will be the same as for following.
File → Save As
Assign a name to the program and save.
Program → Write
Save the program to the controller. This is available only when editing a program.
Note: If there is an error in the program, the error window will be displayed.
Closing the program edit window.
When you close the program after editing, the following message appears.
Yes Program is changed and operation ends. The program is written to the place where it was stored.
No The changes are cancelled and operation ends.
Cancel Program close is cancelled and editing continues.
Note: When saving a program, the program error check is executed automatically. If there is an error, the save operation
will end.