User Manual

Page 84
D2 Override error The override was spec
100%. Specify value w
D3 Angle error The angle parameter fo
was specified outside t
angle within this range.
D4 Axis pattern error The axis pattern design
problem is the same as
Correct the data setting
D5 Axis number error An axis number outside
an axis not supported b
Set the correct axis nu
D6 Circular axis designation error There are data settings
ARC/CIR commands c
dimensions. Correct th
D7 Program number error Operator attempted to
than 64. Only program
D8 Point number error A point number higher
point numbers, only the
D9 Point data error Point data was specifie
Position data must be a
data can be stored as a
DA Flag number error The flag number assign
use numbers 600 ~ 99
DB Variable error The variable number a
and variables with * ind
DC Digit over error The value input in oper
11. Supplement