Manual

15
2. X-SEL-J/K/P/Q/JX/KX/PX/QX
2.3.2 DIP Switch Settings
The DIP switches are used to set the following items:
(1) Node address
(2) Baud rate
(Note) Turn off the X-SEL power before setting the DIP switches.
(1) Setting the node address (MAC ID)
Set the node address (MAC ID) using a hexadecimal value according to the table below.
1: ON 0: OFF
DIP switches
Node address
(MAC ID)
NA32 NA16 NA8 NA4 NA2 NA1
0 0 0 0 0 0 0
1 0 0 0 0 0 1
2 0 0 0 0 1 0
3 0 0 0 0 1 1
      
60 1 1 1 1 0 0
61 1 1 1 1 0 1
62 1 1 1 1 1 0
63 1 1 1 1 1 1
(Note) The node address corresponds to the remote I/O address in the PLC. This DeviceNet card
supports a maximum of 256 input points and 256 output points. Accordingly, the node address
corresponding to the I/O points used will be occupied in the PLC.
Take note that all node addresses must be unique.
(For details, refer to the operation manual for the PLC.)
(2) Setting the baud rate
Set the baud rate according to the table below.
1: ON 0: OFF
DIP switches
Baud rate DR1 DR0
125 kbps 0 0
250 kbps 0 1
500 kbps 1 0
Setting prohibited 1 1