Owner manual

32
5. Installation
5.3 Installing the Slider
x The slider has tapped holes, so affix the load using these holes. Affix the transferring load in the same
manner as you would with the actuator.
x Similarly when the slider is affixed and actuator is moved, install the slider using the tapped holes on the
slider.
x The slider has two reamed holes, so use these holes if repeatability is required after
removal/re-installation. If fine adjustment of squareness, etc., is required, use one reamed hole on the
slider to make adjustment.
Tapped hole sizes and reamed holes of ISD/ISDA/ISPDA/ISDCR/ISPDCR sliders
Type
Tapped
diameter
Tapped
depth
A B C
Reamed
hole
Reamed
depth
S M6 13 mm 70 mm - 60 mm
6H10
10 mm
M6 - 70 mm
MxMX
M8
18 mm
90 mm -
80 mm
8H10
10 mm
LxLX M8 20 mm 120 mm 90 mm 105 mm
8H10
10 mm
Tapped hole sizes and reamed holes of ISDACRxISPDACR Sliders
Type
Tapped
diameter
Tapped
depth
A B C
Reamed
hole
Reamed
depth
S M6 13 mm 70 mm - 60 mm
6H10
10 mm
M6 - 70 mm
8H10
10 mm
M
M8
18 mm
90 mm -
80 mm
8H10
10 mm
M6 - 70 mm
8H10
10 mm
MX
M8
18 mm
90 mm -
105 mm
8H10
10 mm
L M8 20 mm 120 mm 90 mm 105 mm
8H10
10 mm
LX M8 20 mm 120 mm 90 mm 130 mm
8H10
10 mm
Reamed hole
Reamed hole