Owner manual

59
7. Specifi cations
IX-NNW3515 (Arm Length 350, Dust-proof/Splash-proof Specification)
Item Specifications
Type IX-NNW3515-L-T1
Degree of freedom Four degrees of freedom
Overall arm length 350
Arm 1 length 225
Arm 2 length
mm
125
Axis 1 (arm 1) AC servo motor + Speed reducer
Axis 2 (arm 2) AC servo motor + Speed reducer
Axis 3 (vertical axis) AC servo motor with brake + Belt + Ball-screw spline
Drive method
Axis 4 (rotational axis) AC servo motor + Belt + Reduction gear + Spline
Axis 1 (arm 1) 200
Axis 2 (arm 2) 100
Axis 3 (vertical axis) 100
Motor capacity
Axis 4 (rotational axis)
W
50
Axis 1 (arm 1)
r120
Axis 2 (arm 2)
degree
r135
Axis 3 (vertical axis) (*1) mm 150
Movement range
Axis 4 (rotational axis) degree
r360
Axis 1 + Axis 2 (maximum composite speed)
3979
Axis 3 (vertical axis)
mm/sec
1106
Maximum
operating speed
(*2)
Axis 4 (rotational axis) degree/sec 1600
Axis 1 + Axis 2
r0.010
Axis 3 (vertical axis)
mm
r0.010
Positioning
repeatability (*3)
Axis 4 (rotational axis) degree
r0.005
Cycle time (*4)
sec 0.59/2 kg
Rated 1
Load capacity
Maximum
kg
3
Dynamic (*5) 90.9 (9.3)
Push-in thrust of
axis 3 (vertical
axis)
Static (*6)
N (kgf)
65.3 (6.7)
Permissible moment of inertia (*7)
kgm
2
0.015
Permissible load
on axis 4
Permissible torque
Nm (kgfcm)
1.9 (19.5)
Permissible tool diameter (*8)
mm
40
Origin detection Absolute
User wiring (*9)
15-pin waterproof connector with 15-core, AWG26 shielded cable (socket)
Alarm indicator (*10) One small, red LED indicator (rated voltage: 24 V)
Air purge pipe joint
Applicable tube: Outer diameter I6 (inner diameter I4)
User piping
Three air tubes (outer diameter: I4, inner diameter: I2.5)
(normal service pressure: 0.8 MPa)