Owner's manual
Table Of Contents
- Cover
- Please Read Before Use
- Table of Contents
- Safety Guide
- Caution in Handling
- International Standards Compliances
- Names of the Parts
- 1. Specifications Check
- 2. Installation
- 3. Connecting with the Controller
- 4. Operation
- 5. Troubleshooting
- 6. Maintenance and Inspection
- 7. Life
- 8. External Dimensions
- 9. Warranty
- Change History
2. Installation
36
2.3.3 Attachment of Transported Object
• There are tapped holes on the top surface of the slider. Affix the work part (transported object)
here.
• The procedure to affix a load on the slider shall conform to the actuator installation procedure.
• There are two reamed holes on the top surface of the slider. Use these reamed holes if
repeatability of attaching and detaching is required. Also, if small tuning such as perpendicularity
is required, use one of the reamed holes for the tuning.
• Refer to the following table for the screwed depth and reamed depth. Screwing further than
indicated in the table may destroy the tapped hole or lower the reinforcement of the attachment of
the work part, result in the drop of the accuracy or an unexpected accident.
٧Small Type H8SS, H8SM, H8HS, H8HM
REAMED HOLE
PITCH ±0.02
4-M5, depth 10
2-
φ
4H7, depth 8
25
50
25
80
65±0.02
Mounting Bolt
Tapped Hole Size
Nominal Bolt Diameter Tightening Torque
Reamed Hole
M5, depth 10 M5 3.42N·m (0.35kgf·m)
I4H7, depth 8
About Tightening Screws
•
Use a hex socket head cap bolt for the attachment to the base.
• It is recommended to use high-tensile bolts with ISO-10.9 or more.
• Make sure to have the effective length of bolt engagement described below or more for the
tightening of a bolt and a female screw.
When female screw is on steel ĺ Thread length same as nominal diameter
When female screw is on aluminum ĺ Thread length 1.8 times longer them nominal diameter
Caution: • Pay special attention when selecting the bolt length. In case that an inappropriate
length of a bolt is applied, it may cause damage on the tapped holes or insufficiency
in attachment strength, which may result in a drop in the operation accuracy or an
unexpected accident.
• When attaching a transported object, pay attention not to apply a viscous liquid
such as glue or paint on the stainless steel sheet, or not to apply force on a spot,
which could make a dent mark. Doing so may cause an operation error of the slider
or damage on the sheet.