User Manual

Chapter 2 Wiring

3) PROFIBUS-DP Type

5 1

9 6

Cable

Shield

Red B line (Positive side)

Use the type A cable for PROFIBUS-DP (EN5017).

Green A line (Negative side)

Connector Name PROFIBUS-DP Connector

Cable Side 9-pin D-sub Connector (Male) Please prepare separately

Controller Side 9-pin D-sub Connector (Female)

Pin No. Signal Name Description

Applicable cable

diameter

1 NC Disconnected

2 NC Disconnected

B-Line Communication Line B

(RS485)

4 RTS Request for Sending

5 GND Signal GND (Insulation)

Front view of

connector on

controller side

6 +5V +5V Output (Insulation)

7 NC Disconnected

A-Line Communication Line A

(RS485)

9 NC Disconnected

PROFIBUS-DP

Dedicated Cable

Note Connect a terminal resistor (220:) between A-line and B-line if the unit

comes to the end of the network. [Refer to 2.3 [8] Wiring Layout for

Fieldbus.]