Owner manual

[Update mode selector switches]

Switch

Function

ON Update mode

OFF Normal mode

[Model selector switches]

Switch

Function

Set this to ON

(Default setting)

OFF -

[3] Backup battery connector

This connector is used to connect the absolute-data backup battery.

[4] Ni-MH battery

The absolute-data backup battery is stored here.

[5] Power-supply terminal block

The main power (24-VDC) input terminals of this unit are provided.

Note) Connect the simple absolute unit to the same power ground used by the controller to which the unit

is connected.

[6] RCP2/RCP3 connector

This connector is used to connect the PG cable of a RCP2/RCP3 actuator.

[7] RCA/RCA2 connector

This connector is used to connect the PG cable of a RCA/RCA2 actuator.

[8] Host controller connector

This connector is used to send encoder feedback signals to the host controller.

Note) Take note that the cable is different depending on the controller to which the unit is connected.

x PCON/PSEL: CB-PC-***

x ACON: CB-AC-*** *** indicates the cable length. Example) 002: 20 cm

Positive side of the 24-V power supply

Negative side of the 24-V power supply