Manual

4. SCON-CA
190
(31) Standstill Mode Selection (ASO0, ASO1) PLC Output Signals
Select the stop mode to be applied while the actuator is standing by to move to the next position after completing
a positioning.
If the actuator remains standstill for a long time, the servo is turned off automatically to lower the power
consumption.
For details, refer to the operation manual for your controller.
ASO1 ASO0 Functions Remarks
OFF OFF Disabled Factory setting
OFF ON Auto servo OFF mode
T in the chart below corresponds to the setting of parameter No. 36.
ON OFF Auto servo OFF mode
T in the chart below corresponds to the setting of parameter No. 37.
ON ON Auto servo OFF mode
T in the chart below corresponds to the setting of parameter No. 38.
Movement command
Servo status
Actuator movement
Servo ON status
Auto servo OFF mode
(A green LED blinks.)
Delay time until the servo turns off after
completion of positioning (sec)
Target position