Owner's manual
34
4. Installation Method
[RCP2-GR3LS]
Warning Caution
Some of the tapped holes used for installing the gripper are through holes. Therefore, never use long
screws exceeding the effective thread length. They may damage the mechanical or electrical parts
inside the gripper.
(Note) If the gripper is installed
from the rear side, remove
the blank plugs from the
tapped holes.
Detail view of A (2:1)
Installation surface
Installation surface
Installation surface
Installation
surface
depth 3
depth 8
depth 3
(Same on back side)
(Same on back side)
Rear
(Use holes in
the flange)
(Effective depth 6)
Blank plug (Set screw
M4 x 5)
(Same on back side)
2-3
4-4.5
57
57
59