Manual

28
2. Specication
27
2. Specification
(1) Maximum speed
The maximum speed of the actuator is limited to prevent resonance of the ball screw shaft and also in
consideration of the restrictions on motor speed.
Observe the maximum speed limits specified below.
[Cleanroom specification RCS2CR]
Strokes and maximum speed limits (unit: mm/sec)
Caution: Do not set any speed or acceleration/deceleration exceeding the rated speed or
acceleration/deceleration. Doing so may result in vibration, failure or shorter life.
When combining multiple axes and synchronizing their operations, the speed and
acceleration/deceleration to be set should correspond to the highest speed and
largest acceleration/deceleration among those of the combined axes.
In particular, exercise caution because setting an acceleration/deceleration
exceeding the rated acceleration/deceleration may cause the actuator to suffer
creep or the coupling to slip.
50 100 150 200 250 300 350 400 450 500 550 600 700 800 900 1000
SA4
5615.2
0335
56601
SA5
0910023
0830046
06700821
20
1300
800
SA6
5310610910023
0720230830046
045046067008
20
09906110031
800
SA7
0210610024
0420230048
08404600861
SS7
0036
00612
SS8
56201308308400501
515526567069000102
Stroke [mm]
Type
Lead
[mm]
(installed horizontally)
(installed vertically)
(installed horizontally)
(installed vertically)
230
470
12