User guide

Page 68
Posi
Shift Copy Clr Etc
F1 F2 F3 F4
Mdi - 1 No 1 [1] - 8
1.23
4 12.345
123.456 1234.567
Wrt Can Clr Etc
F1 F2 F3 F4
Mdi - 1 No 1[1] - 8
1.23
4 12.345
123.456 1234.567
Axis+ Axis- Vel Etc
F1 F2 F3 F4
Mdi - 1 No 2[2] - 8
1.234 12.34
5
123.456 1234.567
Axis+ Axis- Vel Etc
F1 F2 F3 F4
Mdi - 1 No 8[8] - 8
2345.678 1.234
12.345 1234.5
6
Axis+ Axis- Vel Etc
F1 F2 F3 F4
6-2 Position (Position Data) Input Display 2 (Go back to the
display in Step 5. Press F4)
F1- (Shift) Position Shift Mode (P69. 11-1)
F2- (Copy) Position Data Copy (P69. 11-1)
F3- (Clr: Clear) Position Data Clear (Deletion) (P69.
11-2)
F4- Position (Position Data) Input Display (P67. 5)
Esc- Return to Program Mode (P67. 4)
7. Position Data Input Mode (Step 6-1, Return Key)
Direct input (5-digit integers before decimal point and 3
digits after the decimal point.)
F1- (Wrt: Write) Saving position data
F2- (Can: Cancel) displays xxxx.xxx.
F3- (Clr: Clear) displays 0.000 for data reentry.
F4- Position data input sub menu. (P68. 8)
8. Position Data Input Sub Menu (Step 7. F4)
Direct Input (5-digit integers before decimal point and 3-
digits after the decimal point)
F1- (Axis+) Increments axis number by 1. (P68. 8-1)
F2- (Axis-) Decrement axis number by 1. (P68. 8-2)
F3- (Vel: Velocity) Set velocity and acceleration for
the position number. (P69. 9)
F4- (Etc) Returns to Position Data Input Mode (P68. 7)
8-1 Increments axis number by 1. (Step 8, F1)
8-2. Decrements axis number by 1. (Step 8, F2)
Chapter 2. Operation