Instruction Manual

Operation
Each Jump Ringz band requires a Jump Ringz clip (D) to lock the band in place when in use.
Once the proper band size is set with the pin, cover the pin with the Jump Ringz clip to securely
fasten the band. To remove the clip, simply place the Jump Ringz key (E) on the clip and the
locking mechanism will release the band. Please see the Jump Ringz band image
“loop and lock with Clip and Key.”
**We recommend staff members use fanny pack pouches in order to keep the Jump Ringz
band and Clips together to minimize loss of parts.
To activate the Jump Ringz bands, switch the “On/Off Switch” (1) of the Scanner to the
“On” position. Place the Scanner on the circular top of the Jump Ringz band and pull the
Scanner trigger. If the Jump Ringz band receives the signal properly, the LED will flash five (5)
times to confirm it is operational and the assigned time will begin. The LED on the band will
slowly pulse blue until there is 15 minutes remaining on the wearer's time. Once the wearer's
band begins pulsing red, it will pulse for the remaining 15 minutes and automatically turn off at
its expiration. Note: The Jump Ringz band may be reset at any point by a new activation from
the Scanner. To ensure maximum battery life of the Scanner, please ensure that the Scanner's
“On/Off Switch” is switched to the “Off” position after use.
Jump Ringz