Instruction Manual

Scanner Charging
The Scanner handle has a unique magnetic port (6) that connects to a standard USB cable
for charging. When charging, The Scanner's LED lights will flash to indicate its current
charge power level. When fully charged, all 4 LED lights (9) will be illuminated.
Power Level
The Scanner battery can last up to a week depending on the number of activations. There is
power level indicator on the side of the scanner (4). To determine the Scanner's current
battery level, depress the scanner trigger. The number of LEDs that light up indicates the current
battery power level. All four lights will be illuminated when the Scanner is fully charged.
Jump Ringz Activation
To prepare the Scanner for operation, turn on the unit (1) and select one of the preset time
buttons (3). Direct the scanner antenna (8) to the round face of the Jump Ringz band and
pull the trigger (5). The Scanner should be touch or be close to touching the face of the
Jump Ringz band. Once the time properly set, the scanner will vibrate for approximately
three seconds. If the signal is not transferred, there will be a quick, two pulse vibration to
indicate that the user will need to try again.
Scanner