Installation Guide

1.800.221.0932

iBEAMUSA.com

Camera Wiring

There are two options for powering up the camera.This

camera can be powered to be available while the vehi-

cle is running or to only be used as a back-up camera.

1. Remove the tail light from the vehicle to allow

access to the light bulbs wiring. (If help is need-

ed, review the vehicles owners manual section on

replacing the tail light bulbs.) (Figure A)

2. Find the wiring that connects to the reverse bulb.

There is normally 2 wires. (Figure B) Strip the

insulation to expose the copper wire.

3. Using a Digital Multi-meter on the DC Voltage

setting, to verify the reverse wire. (Figure C)

4. Connect the RED wire to the reverse wire.

Connect the BLACK wire to a chassis ground.

1. Find a reilable 12 volt accessory source in the

vehicle. This can be found at the radio if it is being

replaced with an aftermarket radio.

2. Using a Digital Multi-meter on the DC Voltage

setting, to verify the accessory wire. (Figure C)

3. Connect the RED wire to the reverse wire.

Connect the BLACK wire to a chassis ground.

Figure C

Figure B

Figure A

12 V

- 12V

Select this symbol on the meter

CAMERA WIRING