Installation Guide

REV. DATE 04/24/2020 INSTTE-2MPC
3
1. Run the extension cable to the front of the
vehicle. (Figure A)
2. The RED wire on the YELLOW RCA can be used
in different ways. This wire is the same RED
wire that is at the other end of the extension
cable. (Figure B.1)
If connected to REVERSE in the rear, the
RED wire at the YELLOW RCA can be
used as a reverse trigger for a monitor,
mirror or aftermarket radio.
If connected to 12 volt accessory in the
rear, please cap off this wire on the
YELLOW RCA.
If a REVERSE or 12 volt accessory could
not be found in the rear of the vehicle,
this wire can be used to power the
camera. If this solution is used, cap off
the RED wire in the rear.
3. Connect the YELLOW RCA to the backup
camera or video input of the monitor
4. There are two colored loops on the camera
wire that control on/off functions.
White wire = parking lines
Blue wire = mirror image.
Figure B
Figure A
5 FT 27 FT
1
Figure C
CAMERA WIRING (CONT.)