TE-AJPKT Manual
1. Box Contents Camera and wiring Bracket 2 Push nuts • Applications 2007-2018* Jeep Wrangler (* 2018 JK trim only) • Installation of camera • Run camera wire through stem of bracket, DO NOT pop the camera into the bracket before confirming visual on monitor. • Connect the RED wire to a 12V reverse trigger. • Connect the BLACK wire to a chassis ground. • If reverse signal is needed in the front of vehicle, RED wire with RCA will provide that signal from the red wire in the rear of the vehicle.
4. Wiring diagram 22 ft 2 ft 5. Specifications Sensor Resolution Field of view Illumination IP rating Parking Lines Extension cable TV system Working Temp Warranty CMOS 7080 480 TV Lines Diagonal 170º, Horizontal 110º, Vertical 90º 0.
IMPORTANT If you are having difficulties with the installation of this product, please call out Tech Support line at 386-257-1187. Before doing so, looks over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling. 386-257-1187 REV.
