User's Manual

IS-302
Dual InteliSocket
™
Ibis Networks · 841 Bishop Street Suite 1601 · Honolulu, HI 96813 · www.ibisnetworks.com 3
02/24/16
PUSHBUTTON
The illuminated pushbutton provides addition control features. First and foremost, it is a
manual override for turning the outlet on (green) and off (red). If pressed and held for at least
three seconds it causes a reboot of the socket. If held in for ten seconds (two reboots) it
reverts back into factory mode settings. This is a useful feature for maintenance purposes or
when a socket gets moved from one location to another. A blinking backlight indicates the
socket has not associated with a mesh network yet.
DUAL OUTLETS
The outlets on the IS-302 are metered separately, although only one of them can be turned off.
The “always on” outlet is meant to be used for monitoring a device such as a computer or lamp,
which provides an indication of a user’s presence, and can be used as an event trigger. For
example, when the computer goes into sleep mode, it flags the InteliNetwork software to shut
down the “controlled” outlet. Such behavioral control can potentially lead to greater savings
than fixed time schedules. In typical use, a power strip is plugged into the “controlled” outlet,
providing combined control and monitoring of a number of devices. Thus, the IS-302 offers a
unique, low cost solution for the “desktop” or “cubicle”. Tracking is organized by person, not
device.
TITLE 24
The IS-302 is Title24 compliant.
FCC
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the