Datasheet

Language I Available languages will be displayed
Action: The text on the 8mm Tape Drive LCD is available in several languages. To
change the language:
Press and hold the unload button after you turn the power on to the 8mm Tape Drive or,
if your system unit is already running, press and hold the unload button for
approximately 15 seconds until the LCD displays "RESET".
Release the unload button for approximately one second.
Then press and hold the unload button again.
After the LCD cycles through all the reset messages it cycles through the available
languages. When the desired language displays, release the unload button.
The "Language" prompt appears after the "SCSI ID" message, followed by a list of the
languages in a slow scrolling sequence. When the desired language appears on the
display, release the unload button. The drive RESETS again, even if it is the same
language, and begins with the new/same language.
English
Francais
Deutsch
Espanol
Italiano
Portugues
Load Fail:
Try New
Tape
8003 E F A load command has failed to read the System area of the tape.
Action: Use a new cartridge.
Load Fail:
Press
Eject
8007 E F A load command has failed, or a load or change partitions command has failed to read
the System area of the tape.
Action: Press the eject button.
Load
Lock
1021 I Manual loading is locked. Prevent Media Removal is in operation. displayed.
Load
Tape
2009 I This is displayed when you press the Load Tape Button.
Loading 1003 S Either a cartridge is being moved from the magazine and placed into the drive
mechanism, or the drive is loading a cartridge.
Locate 1016 S The drive is moving the tape to point specified by the host.
Mag
Check
1002 S The autoloader is examining the magazine to find which slots are occupied.
Mag Eject 1001 S The autoloader is ejecting the magazine.
Mag
Loaded
1006 S A magazine is present in the autoloader and the magazine check has been carried out.
Media
Removal
Prevented
8005 E F An eject command has been attempted when Media Removal Prevention is in force.
Action: Try again when the Media Removal Prevention has been removed. This can be
achieved by the host sending a SCSI Allow Medium Removal command, or by resetting
the autoloader, or cycling the power OFF then ON again.
New
FW!!!!
3004 S The firmware upgrade process has been successfully completed.
No EOD
Mark
8016 E F The drive is trying to read what appears to be a blank tape (one with no DDS-Format
EOD pattern). This is probably a result of a power failure while writing the tape.
Press
Eject
2007 I Press the Eject Button.
Read Fail 8012 E F A READ has failed. The host should reposition and try again.
Rewind 1013 S The drive is rewinding the tape.
SCSI 8020 E R A SCSI command error has been detected.
Page 18 of 93Tape Help Package
5/20/2008file://C:\tem
p
\TAPEWHDR.html