Datasheet

z If the error persist, contact your
service provider.
Hardware Error An operation could not be completed
because of a mechanical problem.
z Reset the autoloader and retry the
operation.
z If the error persist, contact your
service provider.
In Enet Mode The autoloader is executing a command
issued from the Remote Management
utility with a command is issued from
the operator panel.
Wait until the autoloader has finished
its current operation, then retry the
operation.
In a Security Mode Choice Rejected Autoloader security has been set from
the application
Disable autoloader security from the
application and retry the operation.
Over Temperature The tape drive's temperature limit has
been exceeded, and the cartridge has
been ejected from the drive.
z Wait until the autoloader has
cooled, then unload the cartridge
to a cell and re-load it into the
tape drive.
z Check the room temperature. The
ambient temperature must be no
more than 40 Degrees C(104
Degrees F).
z Provide additional air flow
around the autoloader to improve
cooling.
POST Failed The autoloader encountered an error
during its power-on self-test.
Reset the autoloader.
Sequential Mode An application tried to issue commands
to the autoloader while it was set to
Sequential mode.
Set the autoloader to Random mode.
Servo Error The autoloader carousel has
experienced a problem
z Reset the autoloader, and retry
the operation.
z If the error persists, contact your
service provider.
Servo Jammed The autoloader carousel has
experienced a problem.
z Reset the autoloader, and retry
the operation.
z If the error persists, contact your
service provider.
Servo Timeout The autoloader carousel has
experienced a problem.
z Reset the autoloader, and retry
the operation.
z If the error persists, contact your
service provider.
System Error The autoloader has experienced a fatal
error.
z Reset the autoloader, and retry
the operation.
z If the error persists, contact your
service provider.
Page 27 of 93Tape Help Package
5/20/2008file://C:\tem
p
\TAPEWHDR.html