Datasheet

Action: Use a Cleaning Cartridge to clean the drive.
Cleaning 1008 S A Cleaning Cartridge has been inserted into the drive and cleaning is being done.
Close
Door
2006 E F The front panel door is open. Any Autoloader motion will be delayed.
Action: Close the front panel door.
Drive
Comms
Error
8002 E F The drive has stopped communicating with the changer mechanism.
Eject Fail 8004 E F An eject command has failed, either after you pressed the Eject button or after a host
command.
Action: Use a new cartridge, or try forcing an eject. To force an eject hold the eject
button for 5 seconds. For a detail of the forced eject refer to "Emergency Ejection" in
the 7332-220 Setup and operator guide.
Eject Mag 2010 I This is displayed when you press the Eject button.
Erase 1015 S The drive is erasing data from the tape.
Error X 8000 E F The mechanism has jammed.
Action: Press the Eject button to attempt to recover the cartridge. If this fails, power the
drive OFF then ON again.
Error: No
tape in
slot 1
4003 I The autoloader requires a cartridge is slot 1.
Error:
Unable to
boot from
tape
4001 I The tape drive cannot boot from Autoloader control tape.
Forced
Eject
1023 I A forced ejection is in progress.
Format 1014 S A SCSI command to generate a tape is being processed.
FW
Check
3002 S Firmware upgrade data is being checked for compatibility.
FW Data
Err
8024 E F The autoloader has failed to upgrade the drive firmware, because the new firmware is
corrupt.
Action: Obtain a good copy of the firmware upgrade.
FW
Program
3003 S The drive is being upgraded with the new firmware.
FW Tape 3005 S The cartridge loaded in the drive mechanism is a firmware upgrade tape.
FW
Upgrade
3001 S Firmware upgrade data is being read either through a tape or the SCSI bus.
FW Read
Fail
8025 E F A firmware upgrade failed because of an error in reading data from the tape.
Action: Try again
FW Tape
Write
Protected
8027 E F A firmware upgrade failed because the tape is write protected.
Action: Change the write protect tab on the tape and try again
FW Write
Fail
8026 E F A firmware upgrade failed because of an error in writing a modified upgrade count to
the tape.
Action: Try again
Insert
Mag
2002 S The autoloader is waiting for you to insert a magazine.
Page 17 of 93Tape Help Package
5/20/2008file://C:\tem
p
\TAPEWHDR.html