- Hewlett-Packard SAN Switch Installation Guide

Modifications
The FCC requires the
user to be notified that any changes or mo difications made to
this device that are not expressly approved by Hewlett-Packard Company my void the
user’s authority to operate the equipment.
Cables
Connections to this device must be made with shielded cables with metallic RFI/EMI
connector hoods in order to maintain compliance with FCC Rules and Regulations.
Re gulatory compliance identification numbers
For the purpose of regulatory compliance certifications and identification, your product
has been assigned a unique Regulatory Model Number. The RMN can be found on the
product nameplate label, along with all required approval markings and information.
When requesting compliance information for this product, always refer to this RMN. The
Regulatory Model Num ber should not be confused with the marketing name or model
number of the product.
The Regulato
ry Model Number for the 4/8 and 4/16 SAN Switches is HSTNM-N005.
The Regulato
ry Model Number for the 4/32 SAN Switch is HSTNM-N003.
The Regulat
ory Model Number for the 4/32B SAN Switch is HSTNM-N012.
The Regulat
ory Model Number for the 4/64 SAN Switch is HSTNM-N 0 08.
Laser device
All HP systems equipped with a laser device comply with safety standards, including
International Electrotechnical Commission (IEC) 825. With specific regard to the laser,
the equipment complies with laser product performance standards set by government
agencies as a Class 1 laser product. The product does not emit hazardous light.
Laser saf
ety warning
WARNING!
To reduce the risk of exposure to hazardous radiation:
• Do not try to open the laser device enclosure. There ar e no user-serviceable
compone
nts inside.
• Do not operate controls, make adjustments, or perform procedures to the laser
device other than those specified herein.
• Allow o
nly HP authorize d service tech nicians to repair the laser device.
114
Regulatory compliance and safety