User's Manual
Table Of Contents
- Safety information
- Chapter 1. General information
- Chapter 2. Server setup road map
- Chapter 3. Product overview
- Chapter 4. Turning on and turning off the server
- Chapter 5. Configuring the server
- Chapter 6. Installing, removing, or replacing hardware
- Guidelines
- Removing the server cover
- Removing and reinstalling the front bezel
- Installing, removing, or replacing hardware
- Installing or removing a memory module
- Installing or removing a PCI card
- Installing or removing the Ethernet card
- Installing or removing the RAID card
- Installing or removing the ThinkServer 9240-8i RAID 5 Upgrade Key
- Installing or removing the ThinkServer SATA Software RAID 5 Key
- Installing or removing the ThinkServer iKVM Remote Management Module
- Installing or removing the TPM module
- Installing or removing the DIT module
- Installing or replacing an optical drive
- Installing or replacing a hot-swap hard disk drive
- Removing or installing a non-hot-swap hard disk drive
- Replacing the hot-swap hard disk drive backplane
- Replacing the non-hot-swap power supply assembly
- Replacing a hot-swap redundant power supply module
- Replacing the power distribution board and cage assembly
- Replacing the front panel board assembly
- Replacing the front system fan
- Replacing the rear system fan
- Replacing the heat sink and fan assembly
- Replacing the microprocessor
- Replacing the system board battery
- Completing the parts replacement
- Chapter 7. Troubleshooting and diagnostics
- Chapter 8. Getting information, help, and service
- Appendix A. Notices
- Index
2.Removetheservercover.See“Removingtheservercover”onpage85.
3.Removethefrontbezel.See“Removingandreinstallingthefrontbezel”onpage87.
4.Locatethehot-swapharddiskdrivebackplane(s).See“Hot-swapharddiskdrivebackplane”on
page34
.
5.Removethefrontsystemfan.See“Replacingthefrontsystemfan”onpage149.
6.Removealltheinstalledhot-swapharddiskdrivesanddummytrays(ifany)fromtheharddiskdrive
cage.See“Installingorreplacingahot-swapharddiskdrive”onpage119
.
7.Notedownthecableconnectionsonthebackplaneandthendisconnectallthecablesfromthe
backplane.
8.Liftthereleaselatch1andslidetheharddiskdrivecageoutofthefrontofthechassis.
Note:Thefollowingillustrationshowsthe3.5-inchharddiskdrivecage.Forthe2.5-inchharddisk
drivecage,theremovalprocedureisthesame.
Figure71.Removingtheharddiskdrivecage
9.Dependingonwhetheryourserverhasa2.5-inchhot-swapharddiskdrivecagewithbackplaneor
3.5-inchhot-swapharddiskdrivecage(s)withbackplane(s),dooneofthefollowing:
134ThinkServerUserGuide