User's Manual
Table Of Contents
- Safety information
- Chapter 1. General information
- Chapter 2. Server setup road map
- Chapter 3. Product overview
- Chapter 4. Turning on and turning off the server
- Chapter 5. Configuring the server
- Chapter 6. Installing, removing, or replacing hardware
- Guidelines
- Removing the server cover
- Removing and reinstalling the front bezel
- Installing, removing, or replacing hardware
- Installing or removing a memory module
- Installing or removing a PCI card
- Installing or removing the Ethernet card
- Installing or removing the RAID card
- Installing or removing the ThinkServer 9240-8i RAID 5 Upgrade Key
- Installing or removing the ThinkServer SATA Software RAID 5 Key
- Installing or removing the ThinkServer iKVM Remote Management Module
- Installing or removing the TPM module
- Installing or removing the DIT module
- Installing or replacing an optical drive
- Installing or replacing a hot-swap hard disk drive
- Removing or installing a non-hot-swap hard disk drive
- Replacing the hot-swap hard disk drive backplane
- Replacing the non-hot-swap power supply assembly
- Replacing a hot-swap redundant power supply module
- Replacing the power distribution board and cage assembly
- Replacing the front panel board assembly
- Replacing the front system fan
- Replacing the rear system fan
- Replacing the heat sink and fan assembly
- Replacing the microprocessor
- Replacing the system board battery
- Completing the parts replacement
- Chapter 7. Troubleshooting and diagnostics
- Chapter 8. Getting information, help, and service
- Appendix A. Notices
- Index
Menuitem
SubmenuitemSelectionsComments
•Poweron
Ifthepowerisinterrupted
whentheserverison,after
thepowerresumes:
•IfyouhaveselectedStay
off,theserverwillstayin
theoffstate.
•IfyouhaveselectedLast
State,theserverwill
resumetothelaststate.
•Ifyouhaveselected
Poweron,theserverwill
restartautomatically.
SATAMode
•IDEMode
•AHCIMode
•RAIDMode
SelectSATAcontroller
operationmode.Ifyou
wanttocongureRAID,
chooseRAIDModeforthe
SATAcontroller.
SATAPort0
Viewtheinformationabout
theSATAdeviceconnected
totheSATAconnector0on
thesystemboard.
SATAPort1
Viewtheinformationabout
theSATAdeviceconnected
totheSATAconnector1on
thesystemboard.
SATAPort2
Viewtheinformationabout
theSATAdeviceconnected
totheSATAconnector2on
thesystemboard.
SATAPort3
Viewtheinformationabout
theSATAdeviceconnected
totheSATAconnector3on
thesystemboard.
SATAPort4
Viewtheinformationabout
theSATAdeviceconnected
totheSATAconnector4on
thesystemboard.
SATAConguration
(setSATAconguration
parameters)
SATAPort5
Viewtheinformationabout
theSATAdeviceconnected
totheSATAconnector5on
thesystemboard.
OnboardGraphics
Controller
•Disabled
•Enabled
Enableordisable
theonboardgraphics
controller.
PrimaryGraphics•Onboard
•Add-On
Chooseamodeforprimary
graphics.TheAdd-On
optionrequiresagraphics
cardinstalled.
OnboardLAN1I/OROM
•Disabled
•Enabled
Enableordisablethe
onboardLAN1I/OROM.
PCIConguration(setPCI
congurationparameters)
Chapter5.Conguringtheserver59