User Guide

IBU-33415
sPro2 Kit
Insert phone by
pushing latch
upwards
Insert Phone
Extend feet to
match phone
width
Adjustable Feet:
Clean surface. If surface is hard,
attach mount directly to
dashboard. For soft surface, use
dashboard disc.
Dashboard Mounting:
Insert the suction mount to the back of the sPro 2.
Use the tightening ring to create a firm fit.
Attach Suction Mount to Vehicle Dock:
DISCLAIMER: The sticky suction mount is only recommended for hard, flat
surfaces. A semi-permanent or permanent indentation may occur if used on
surfaces made of soft leather, vinyl, or similar materials. iBOLT is not responsible
for any damages caused to your dashboard due to the installation or use of the
sticky suction mount. Do not install any mount or holder over an airbag cover or
within the airbag deployment zone.
2
Step 2
Slide latch to
desired height.
3
Step 3
Lock tabs.
Latch Locking System
Step 1
Unlock tabs.
1