Daim Ntawv Qhia Tus Neeg Siv

iBoot-G2 Quick Start © 2021 Dataprobe Inc. V210331W
What’s Included
 iBoot-G2 Unit
 Power Input Cable for North America
 Power Outlet Cable for North America
 Network Cable
 Quick Start Guide
Available Online at
dataprobe.com/support-iboot-g2/
 Complete Product Manual
 Device Management Utility
 Latest iBoot-G2 Firmware
 Software Developer Tools
Connections
1. Connect Network. iBoot-G2 supports 10/100 Ethernet using the cable
supplied, or other suitable unshielded twisted pair (Cat 5) cabling. When power is
connected to the iBoot-G2, the green Activity LEDs on the network connector
indicates when the network connection is properly established.
2. Connect Powered Device. Connect the device to be powered ON and OFF
to the IEC receptacle marked A/C Outlet. An IEC-320 to North American (NEMA 5-
15) power cord is included for connecting the iBoot outlet to the device to be
controlled. If the device has a power switch, turn it on, to allow iBoot-G2 to control
the power.
Make sure that the combined load of all controlled devices
does not exceed 12 Amps for 105-125VAC or 10 Amps for 210-
240VAC.
3. Connect Power Mains Connect the supplied power cord to the connector
labeled AC Input, and the other end to your AC source. If a power cord with a
different terminating plug is required, be sure it is properly rated and meets all the
required local electrical standards.
Web Browser Access
Factory Default IP Address: DHCP Set or 192.168.1.254
Factory Default Security Credentials:
The password is unique and based on the last 3 segments of the MAC address.
The MAC address can be found on a sticker on the bottom of the unit.
ex: If your MAC address is 00-0d-ad-aa-bb-cc then the password is adminaabbcc.
Role
Username (fixed)
Password
Administrator
admin
admin<last 3 MAC segments>
Discover and/or Set the IP Address
If you network supports DHCP, the IP address of the iBoot will be
automatically assigned. Find the IP Address of the iBoot using either from the
DHCP Router/Server or use the Dataprobe Device Management Utility (DMU),
available at dataprobe.com/support-iboot-g2/. See Page 2 for more in the
DMU.
Point your browser to the IP Address of the iBoot, then enter the Administrator
Username and Password to access the complete setup features. Once the
user is validated, the Control and Status is displayed.
To control the power, click on the appropriate button. During power cycling,
the Power Status bar will indicate the temporary status, with a blue
background. Once the cycle is complete, the status bar will revert to its
original condition.
Quick Start Guide
Fig.1 Connect Network
Fig. 2 Connect Device
Fig. 3 Connect Power
Fig. 4 Status and Control Page