Instruction Manual

Speed Dome Camera Instruction Manual 20/57

③ Connect the wires and cables to the ports

and install the main body. (Machine M3×8)

④ Align the dome cover stud with the dome

cover assembly stud and slightly push the

dome cover to the ceiling. Turn the dome

cover clockwise and screw on the dome

cover lock-up screw. Then remove the

protection vinyl from the dome cover.

(Machine M3×6)

Important Notice

z Before starting the installation, make sure that the Camera ID and Protocol are set up properly.

z When the pipe hole for wiring and cabling on side of the Surface Mount Bracket is not used, make sure

that the hole is properly sealed with the supplied Hole Plug.

z To adjust the installation height from the mounting surface, the pipe and coupler should be needed

between the surface mount part of the ceiling mount bracket and the camera mount part of the ceiling

mount bracket. Note that they are not supplied by the manufacturer.

INSTALLATION