Instruction Manual

Speed Dome Camera Instruction Manual 48/57

Pattern Setup

PATTERN SETUP

------------------------

PATTERN NO. 1

UNDEFINED

CLR PATTERN CANCEL

RUN PATTERN

BACK

EXIT

 Pattern Edit

EDIT PATTERN 1

------------------------

MOVE TO START POSITION

[NEAR:START /FAR:CANCEL]

EDIT PATTERN 1

[NEAR:SAVE /FAR:DELETE]

0/0/x1/N

z Pattern Number [1~4 ]

Selects a Pattern number to edit. If the

selected pattern number is not

defined, "UNDEFINED" will be

displayed under the selected pattern

number.

z Clear Pattern [CANCEL/OK]

Deletes the data of the selected pattern.

z Run Pattern Runs the Pattern for the test purposes to

check if it works properly.

z Edit Pattern Edits the selected pattern.

①

ith the Joystick of your controller, move the camera to

the start position with an appropriate zoom

magnafication. To start the pattern recording, press

NEAR key. To exit, press FAR key.

② Move camera with joystick of controller or run preset

function to memorize the path (mostly curve path) in the

selected pattern. The movement by Joystick and preset

movement will be memorized in a pattern. After a

pattern is programmed, the remaining storage is

displayed in progress bar on the screen.

③ To save the data and exit, press NEAR key. To cancel

saving the data and delete the data, press FAR key.

OSD MENU